ESP32 Control

ESP32 MCP Server

Control and read ESP32 IoT devices directly from AI agents (Claude, Cursor, any MCP client).

• esp32.status — online / chip / free heap / uptime
• esp32.gpio_set — set a GPIO high/low
• esp32.gpio_read — read a digital pin
• esp32.adc_read — read analog voltage (mV)
• esp32.send_command — raw AT/application command
• esp32.reboot — reboot the device

Architecture

AI agent (Claude/Cursor)  →  this MCP server (Python)  →  ESP32 REST API  →  device

The ESP32 runs a tiny MicroPython firmware (esp32_firmware/main.py) exposing a lightweight REST API on port 80. The MCP server talks to it over HTTP — works locally and remotely.

Quick start

1. Flash the ESP32 firmware

1. Install MicroPython on your ESP32.
2. Upload esp32_firmware/main.py as main.py (Thonny or mpremote).
3. Power on — the device opens a WiFi AP named ESP32-MCP (password 12345678) or you can set STA mode inside the firmware to join your network.

2. Run the MCP server

pip install esp32-mcp
export ESP32_HOST=http://192.168.4.1     # device address (AP default)
esp32-mcp                                  # stdio transport (local MCP client)

For remote agents, run with HTTP transport:

uv run esp32-mcp --transport http --port 8000

3. Add to your AI client

Claude Desktop (claude_desktop_config.json):

{
  "mcpServers": {
    "esp32": {
      "command": "esp32-mcp",
      "env": { "ESP32_HOST": "http://192.168.4.1" }
    }
  }
}

Cursor: Settings → MCP → Add server → esp32-mcp with env ESP32_HOST.

Then just ask: "turn GPIO 2 on", "what's the ADC reading on pin 34?", "reboot the device".

Configuration

Safety

• GPIO outputs are limited to pins 2, 4, 5, 18, 19 by default (edit GPIO_OUT in the firmware to change).
• The firmware only listens on its own network; change the AP password before exposing to the internet.

Pricing

Free is not a trial — core tools work forever. Upgrade when you need scale.

License

MIT